Ajax Приемник радиодатчиков RR-104 (000000712)

Specs Ajax Приемник радиодатчиков RR-104 (000000712)

Receivers:

Receiver

Readers and management tools:

Central

Description:

Receiver of wireless sensors designed to connect wireless sensors Ajax series CONQUISTADOR to any wired burglar Central unit with the NC inputs. The principle of operation is very simple: Ajax RR-104 are equipped with a radio receiver and the NC transistor outputs. Using conventional wiring receiver outputs connect to the inputs of the Central unit. Therefore, the NT outputs of the receiver be similar to the conventional wired sensors to inputs of the Central unit. Wireless triggering sensor, it sends a signal to the receiver. The receiver receives it, handles and opens the corresponding sensor output. Central, in turn, sees an open receiver output as an open loop sensor and generates an alarm. Functions and features Wireless Protocol Receiver is compatible with all sensors working in the Protocol CONQUISTADOR Receiver regularly monitors the test signals transmitted to the Central unit. If the sensor will try to steal or break, You know immediately about this Transmitted information is protected from interception with floating code Max. distance between sensor and receiver is up to 600 m(assuming line of sight). Such long range is achieved through the use of a special antinoise coding and single-chip superheterodyne receiver. The receiver Allows to make any wired exchange wireless Receiver receives signals from radio channel sensors and with outputs open signals connected wired to the Central Receiver is equipped with 12ью NC transistor outputs (lift to the ground). Maximum switching current/voltage outputs 8 answer 8 security zones. To each zone cannot be ascribed to 4 security sensor or key FOB. If the assigned sensor – output when an alarm is open for 1 s. if the prescribed key output works in bistable mode postanovki/disarm 4 output is used for transmission of service signals: triggering of the tamper sensor, no signal test, low battery, jamming the radio channel. If you experience one of the service event – a service outlet is opened. The receiver monitors the correct operation of the sensors in the network. If the signal of the test sensor is not received, immediately issued the alert Receiver monitors the battery sensors. In the case that the battery is one of the sensors is discharged immediately issued the alarm Receiver detects jamming of the radio channel attackers. If the jammers immediately issued an alarm For the detection and jamming uses an adaptive algorithm that allows to avoid false positives due to the natural interference in the radio channel, the receiver being the log service and log alarm events – you can always see in which specific sensor was triggered tamper switch, or the battery, which sensor has sent the alarm. The receiver is equipped with a special testing mode, which allows to determine the ratio signal/noise for each sensor. This mode allows you to choose the optimal installation place for the sensor Supports SMA antenna to increase the range of work Characteristics: Number of outputs: 12 output Type: transistor Maximum switching voltage/current: 20V/0.5 A DC number of alarm outputs: 8 number of service outlets: 4 Type of radio: PCSC working frequency: 868 MHz transmission Range: 550 m Maximum number of connected devices: 40 Voltage: 12V/ 1A DC operating temperature Range: 0°C ~ +40°C operating humidity: 90% maximum Board size: 83х58х25 mm ... show more show less